Connection To Network - Fujitsu IP-920E Hardware User's Manual

2.4
2.4
To connect IP-920E/IP-920D to a LAN device, connect the LAN device to the LAN communication
port of IP-920E/IP-920D using a LAN cable (UTP cable). The LAN communication port specification
of IP-920E/IP-920D is 10BASE-T/100BASE-TX.
The figure below shows the connection method.
For details about connectors and cables, refer to Section 4.2, "Cable and Connector
NOTE:
Details." For electrical specifications, refer to Appendix 2.3, "Function Specifications."
100-240V
Please do not provision the IP address below.
・ IP address commonly unused（0.0.0.0, 255.255.255.255, etc...）
・ Loop back address (127.xxx.xxx.xxx)
・ Class D and Class E addresses
・ IP address already used
For more information, refer to IP-920E/IP-920D Software User's Guide.

Connection to Network

PWR ALM
RDY
FG
Hub, Router, PC, etc.
Figure Connection to a network
CAUTION
10/100BASE RS-232C
E
100M
OPT
LINK
IN
/ACT
DWN
MNT
41
Chapter 1 Preparations
ANALOG AUDIO IN
IP-920E/IP-920D