Table of Contents
Advertisement
2.3
2.3
2.3.1
IP-920E (Encoder)
2 Digital and 1analog video input connectors are equipped for connecting with video output
equipment.
- SDI Video Input (Digital Video)
Connect to SDI IN connector using BNC cable. Input digital HD-SDI or SD-SDI signal.
The signal is terminated with 75Ω impedance.
- HDMI Input (Digital Video)
Connect to HDMI connector on front panel of IP-900E using the HDMI cable.
Input digital signal of HDMI. The signal is terminated with 50Ω.
- Analog Video Input
Connect to ANALOG VIDEO IN connector using BNC cable with NTSC or PAL signal.
2 Digital and 1analog audio input connectors are equipped for connecting with audio output
equipment.
- Digital Audio Input
SDI Embedded Audio and HDMI audio are supported.
- Analog Audio Input
Connect to ANALOG AUDIO IN connector of IP-920E using the audio adaptor cable.
The figure of cable connections are shown below.
For details about connectors and cables, refer to Section 4.2, "Cable and Connector
NOTE:
Details." For electrical specifications, refer to Appendix 2.3, "Function Specifications."
100-240V
Audio and Video Device Connections
10/100BASE
E
PWR ALM
OPT
RDY
IN
DWN
FG
MNT
Video & Audio Output Device
Figure Audio and video output device connections
RS-232C
ANALOG AUDIO IN
100M
LINK
/ACT
or
39
Chapter 2 Installation and Connection
Audio adapter cable#1
or
Audio adapter cable#3
or
PUSH
PUSH
IP-920E/IP-920D
Advertisement
Table of Contents
