Toshiba RAS-25E2KVG-ND Service Manual page 97

No. Part name
Cross flow fan
10
Procedures
1) Follow the procedure item 3 and 4 .
2) Loosen the set screw of the cross flow fan.
3) Remove 4 fixing screws from the bearing
base then remove it from the main unit.
4) Lift up the heat exchanger follow the figure.
Pull out the left hand side until the cross flow
fan is released from the shaft of the fan
motor and then pull out the lower side of
heat exchanger follow the figure.
<To re-installation>
1) To incorporate the fan motor and the
motor into the position in the following
figure.
- Install the cross flow fan so that the right
end of the 1st joint from the right of the
Cross flow fan is keep 3.5mm from
closed wall of the main unit.
Cross ow fan
3.5 mm
Set screw
- Holding the set screw, install the
cross flow fan so that flat area on shaft of
the fan motor comes to the mounting hole
of the set screw.
Body back
Fan motor
- 97 -
Remarks
Heat exchanger
Bearing base Cross flow fan
Heat exchanger
Cross flow fan