Toshiba RAS-25E2KVG-ND Service Manual page 93

No. Part name
3
Front panel
Electric part
4
box assembly
Procedures
1) Stop operation of the air conditioner and turn
off its main power supply.
2) Open two screw caps and securely remove
screws (2 pcs.) at the front panel.
3) Take off the hooks of front panel from top side
of the back body.
4) Slightly open the lower part of the front panel
then pull the upper part of the front panel
toward you to remove it as shown on figure.
1) Follow the procedure item 3 .
2) Remove screw holding the electric part cover.
TA sensor
Earth line
TC sensor
3) Disconnect the connectors for the fan motor
and louver motor from P.C. board assembly.
Earth screw
Earth line
Washer
4) Remove the earth screw and earth line from
evaporator.
5) Pull out TC sensor from sensor holder of the
evaporator.
6) Remove the 2 fixing screws that secures the
electric parts box assembly, unit display
assembly and remove the electric parts box
assembly.
Hooks of
front panel
Front panel Back body
Fan motor connector
Louver motor connector
TC sensor
Sensor holder
- 93 -
Remarks
Screw
Screw
Screw cap
Screw
Electric part cover
Electric parts box
Screw
Screw
Unit display
Front panel
Connectors