Solid-State Drive - HP EliteBook 1040 Maintenance And Service Manual

2. Press down on the module until the side retention clips snap into place (3).

Solid-state drive

To remove the M.2 solid-state drive, use this procedure and illustration.
Table 5-7 Solid-state drive descriptions and part numbers
Description
2 TB, M.2 2280, PCIe-4×4, ZTurbo solid-state drive with TLC
1 TB, 2280, PCIe-4×4, NVMe solid-state drive with TLC
1 TB, M.2 2280, PCIe-4×4, SED solid-state drive with TLC
512 GB, 2280, PCIe-4×4, NVMe solid-state drive with TLC
512 GB, M.2 2280, PCIe-4×4, NVMe solid-state drive
512 GB, M.2 2280, PCIe-4×4, NVMe, value solid-state drive
512 GB, M.2 2280, PCIe-4×4, SED solid-state drive with TLC
256 GB, M.2 2280, PCIe-4×4, NVMe solid-state drive
256 GB, M.2 2280, PCIe-4×4, NVMe, SED solid-state drive with TLC
Solid-state drive shield: Included in the Bracket Kit, spare part number N09030-001.
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
48 Chapter 5 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page 38).
Spare part number
M52027-001
M16560-001
N23415-001
M17436-001
N45476-001
N04490-001
M52031-001
N45477-001
M35225-001
L85354-001
Battery on page 40).
38).