Removing The Fork Legs; Installing The Fork Legs - KTM 250 SX 2020 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.5
11.6
46

Removing the fork legs

K01143-10
K01174-10

Installing the fork legs

H01182-10
K01174-11
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
Main work
–
1
Remove screws and take off the clamp.
–
2
Remove screws and take off the brake caliper.
–
Allow the brake caliper and brake line to hang loosely to the
side.
Info
Do not actuate the hand brake lever when the front
wheel is removed.
–
3
Loosen screws . Remove the left fork leg.
–
4
Loosen screws . Remove the right fork leg.
Main work
–
Position the fork legs.
1
Air bleeder screw
the front.
A
Valve of the left fork leg faces the front.
Info
Grooves are milled into the side of the upper end of the
fork legs. The second milled groove (from the top) must
be flush with the upper edge of the upper triple clamp.
The air suspension is located in the left fork leg. The
pressure and rebound damping is located in the right
fork leg.
–
2
Tighten screws .
Guideline
Screw, top triple
clamp
–
3
Tighten screws .
Guideline
Screw, bottom triple
clamp
p. 44)
( p. 87)
of the right fork leg is positioned to
M8 17 Nm (12.5 lbf ft)
M8 12 Nm (8.9 lbf ft)