KTM 250 SX 2020 Owner's Manual page 82

12 BRAKE SYSTEM
80
Info
Make sure that you do not press the brake caliper
against the spokes when pushing back the brake
pistons.
–
Remove cotter pins
brake linings.
–
Clean the brake caliper and brake caliper bracket.
101737-10
–
Check that spring plate
7
plate in the brake caliper bracket are seated correctly.
100397-01
–
Insert the new brake linings, insert pin, and mount cotter pins.
Info
Always change the brake linings in pairs.
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
101738-01
–
Correct the brake fluid quantity to level
Guideline
A
Level (brake fluid level
below reservoir rim)
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the membrane. Mount and tighten the
screws.
K00521-10
Info
Clean up overflowed or spilled brake fluid immediately
with water.
4 5
, pull out pin , and remove the
6
in the brake caliper and sliding
A
.
5 mm (0.2 in)
p. 124)