Polaris RANGER XP 1000 Northstar Edition 2017 Owner's Manual page 84

MAINTENANCE
Brakes
The front and rear brakes are hydraulic disc type brakes activated by the brake pedal. See
page 28.
Brake Fluid
Inspect the brake system routinely. Inspect the level of the brake fluid before each operation.
WARNING! After opening a bottle of brake fluid, always discard any unused portion. Never store or
use a partial bottle. Brake fluid is hygroscopic, meaning it rapidly absorbs moisture from the air. The
moisture causes the boiling temperature of the brake fluid to drop, which can lead to early brake fade
and the possibility of accident or severe injury.
WARNING! Do not perform maintenance immediately after the vehicle has been running, as the break
system becomes very hot. Serious burns could result from contact with the brake components. Allow
components to cool sufficiently before proceeding. Wear eye protection and gloves.
Change the brake fluid every two years and any time the fluid becomes contaminated, the
fluid level is below the minimum, or if the type and brand of the fluid in the reservoir are
unknown.
1. Position the vehicle on a level surface.
2. Place the transmission in PARK.
3. View the brake fluid level at the reservoir in the driver's
side wheel well.
4. The level should be between the upper (MAX) and
lower (MIN) level lines.
5. If the fluid level is lower than the upper level line, add
brake fluid to the upper (MAX) line.
6. Apply the brake forcefully for a few seconds and check
for fluid leakage around the fittings.
82
Maximum
Minimum