Polaris RANGER XP 1000 Northstar Edition 2017 Owner's Manual page 33

Seat Belts
This POLARIS vehicle is equipped with three-point lap and diagonal seat belts on all seats.
Always make sure the seat belts are secured for all riders before operating.
The driver's seat belt is equipped with a seat belt interlock. Vehicle speed will be limited to
15 MPH (24 km/h) if the seat belt is not secured.
WARNING! Falling from a moving vehicle could result in serious injury or death. Always fasten your
seat belt securely before operating or riding in the RANGER.
To wear the seat belt properly, follow this procedure:
1. Pull the seat belt latch downward and across your chest
toward the buckle at the inner edge of the seat. The belt
should fit snugly across your hips and diagonally across
your chest. Make sure the belt is not twisted.
2. Push the latch plate into the buckle until it clicks.
3. Release the strap, it will self-tighten.
4. To release the seat belt, press the square red button in the
buckle's center.
Seat Belt Inspection
Inspect all seat belts for proper operation before each use of
the vehicle.
1. Push the latch plate into the buckle until it clicks. The latch plate must slide smoothly
into the buckle. A click indicates that it's securely latched.
2. Push the red release latch in the middle of the buckle to make sure it releases freely.
3. Pull each seat belt completely out and inspect the full length for any damage, including
cuts, wear, fraying or stiffness. If any damage is found, or if the seat belt does not
operate properly, have the seat belt system checked and/or replaced by an authorized
POLARIS dealer.
4. To clean dirt or debris from the seat belts, sponge the straps with mild soap and water.
Do not use bleach, dye or household detergents.
FEATURES AND CONTROLS
Latch Plate
Buckle
31