Table of Contents
Advertisement
1.800.561.8187
3-1. Inserting the Battery
1)... Requires...type-AA...1.5-volt...battery....
2)... Slide...the...battery...cover...in...the...
direction...of...the...arrow...to...remove....
Slide...down...Battery...Cover ⑨ in...the...
direction...of...the...allow...to...move.
3)... Insert...the...battery...observing...the...
polarity...with...the...+,...- marks...in...the...
battery...compartment.
4)... Align...Battery...Cover ⑨ with...main...
unit...and...slide...shut....
... Make...sure...that...the...cover...is...properly...
in...place...and...closed....
● Do not place batteries in open flame, attempt to short them,
disassemble them, apply heat to them, or recharge them
(except rechargeable batteries). They may burst and cause
fires, serious injury, or damage to the environment.
●
Please insert the battery minus "-" side first. When removing
the battery, remove it plus "+" side first.
●
If the meter will not be used for an extended period of time,
it is recommended to remove the battery to avoid possible
damage caused by battery leaking.
3-2. Power ON/OFF
Power...ON... :...Press...the...Power...Button...① .
Power...OFF... :...Press...and...hold...the...Power...Button...①...for...1...second...or......
longer...and...the...meter...will...turn...off.
●
A three second pause between power ON and OFF is
recommended to avoid damage to the meter.
●
If the LCD does not light, check that the battery capacity is
sufficient, and check that the battery positive and negative
terminals are not reversed.
www.
.com
3. Before Using
⑨ Battery
... Cover
information@itm.com
Advertisement
Table of Contents
