1.800.561.8187
5-1. Continuous Measuring Mode
Press...the...Measuring...Button ④ ,...and...the...measured...value...is...displayed...
according...to...the...Illuminance...change.
1) Press...the...Mode...Button ③ and...enter...the...Continuous...Measuring...
Mode.
... ("C"...is...displayed...at...the...upper...right...corner...of...the...LCD.)
2)... Press...the...Measuring...Button ④ and...read...the...measured...value...after...
confirming...that...it...becomes...stable....Press...the...Measuring...Button ④
again...to...hold...the...illuminance...value...at...the...time....
● Try to minimize the influence of the person taking the
measurement or other to the light receptor.
● Collimate the light receptor against the light source when
taking measurements.
● Auto power off function doesn't work in continuous measuring
mode.
● It is not possible to enter the timer measuring mode even
if the Timer Button ⑧ is pressed while measurement in
continuous measuring mode.
It is possible to take a measurement without the influence of
●
surroundings if the person taking measurements move away
and using the timer measuring function. (See Page 10.)
When brightness (or darkness) exceeds the measuring range
●
of the product, "OVER" (or "UNDER") will blink to indicate that
measuring is not possible.
5-2. Single Measuring Mode
Measured...value...is...displayed...when...the...Measuring...Button...is...
pressed.
1)... Press...the...Mode...Button ③ and...enter...the...Single...Measuring...Mode.
... ("S"...is...displayed...in...the...upper...right...corner...of...the...LCD.)
2)... Press...the...Measuring...Button ④ and...display...the...illuminance...at...
the time.
When brightness (or darkness) exceeds the measuring range
●
of the product, "OVER" (or "UNDER") will blink to indicate that
measuring is not possible.
www.
.com
5. Measurement
information@itm.com