Thermal sensor
Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
For access, do the following:
1. Remove the computer cover. See "Computer cover" on page 48.
2. Remove the front bezel. See "Front bezel" on page 49.
3. Remove the optical drive, if any. See "Optical drive" on page 50.
4. Remove the hard disk drive, if any. See "Hard disk drive" on page 51.
5. Disconnect the thermal sensor cable from the system board.
Removal steps
Front Wi-Fi antenna
Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
For access, do the following:
1. Remove the computer cover. See "Computer cover" on page 48.
2. Remove the front bezel. See "Front bezel" on page 49
3. Remove the optical drive. See "Optical drive" on page 50
4. Remove the hard disk drive. See "Hard disk drive" on page 51
5. Remove the hard disk drive. See "Wi-Fi card" on page 60
66
neo 50s Gen 3 Hardware Maintenance Manual