Table of Contents
Advertisement
5. Disconnect the storage drive activity indicator cable from the system board.
6. Remove the storage drive activity indicator.
7. Install the storage drive activity indicator.
8. Reinstall the removed parts.
9. Place the computer in an upright position.
10. Reconnect the power cord and all disconnected cables to the computer.
Thermal sensor
Prerequisite
Before you start, read Chapter 1 "Important safety information" on page 1 and print the following
instructions.
Replacement procedure
1. Remove the computer cover. See "Computer cover" on page 46.
2. Remove the front bezel. See "Front bezel" on page 48.
3. Remove the optical drive. See "Optical drive" on page 49.
4. Remove the storage drive bracket. See "Storage drive" on page 50.
5. Disconnect the thermal sensor cable from the system board.
.
Chapter 6
Hardware removal and installation
55
Advertisement
Table of Contents
