Preparing The Remote - Hunter Houston Installation Manual

1886
The remote control is
already paired for use. For
your convenience, a remote
function card is packed in
with your remote.
NOTICE
• Always purchase the correct size and grade of
battery most suitable for the intended use.
• Replace all batteries of a set at the same time.
• Clean the battery contacts and also those of the
device prior to battery installation.
• Ensure the batteries are installed correctly with
regard to polarity (+ and -).
• Remove batteries from equipment which is not to
be used for an extended period of time.
• Remove used batteries promptly.
You have two options for installing the remote cradle.
Choose which path works best for you.
Option 1: Using Adhesive Strip
Separate the lining
from the back of the
Remove the cradle from
adhesive strip on
the cradle bracket.
the cradle bracket.
9
Ceiling Bracket

Preparing the Remote

Installing the Remote Control Cradle
Press the cradle
bracket against the
wall and hold firmly
for 30 seconds.
Downrod Hanging Fan
To close the battery
compartment, secure
the battery door to the
transmitter assembly with
the small Phillips head screw.
Replace with a CR2032
battery when necessary. The
battery should be installed
with the positive (+) side up.
Battery
Door
Phillips
Head
Screw
Option 2: Using Screws
Choose your cradle
installation location.
If you are installing into drywall, drill two
9/64 width holes using the cradle bracket
as a guide. Gently hammer the included
drywall anchors into the pre-drilled holes.
Wiring Canopy
Remote Function Guide
Key Press Function
+ Quick Press Light On/Off
+ Long Press Light Dimming
+ Quick Press Fan On/Off
+ Quick Press Raise Fan
Speed
Lower Fan
+ Quick Press
Speed
Long Press Fan High
Fan Low
Long Press
Long Press
+ Dimming Mode
On/Off
Slide the cradle onto
the mounted bracket.
Blades Bulbs
ON
Remote