Mounting The Device With Clamping Frame And Mounting Clips - Siemens MTP700 Unified Comfort Hygienic Compact Operating Instructions

Installing and connecting the device
3.2 Mounting the device
3.2.4

Mounting the device with clamping frame and mounting clips

This section describes the design of the hygienic HMI devices using the MTP1500 Unified
Comfort Hygienic as an example.
Requirement
For mounting you need:
• The supplied clamping frame
• A torque screwdriver with 2.5 mm hex socket insert
• The mounting clips and set screws from the accessory kit
Screw the set screws into the mounting clips before mounting.
Note
Two short set screws for MTP700
The MTP700 accessory kit contains two additional short set screws. These are needed if
the material at the mounting cutout is more than 1.5 mm thick. In this case two of the
long set screws are not needed and can serve as spares.
Procedure
Risk of injury when device falls
An unsecured device may fall. This can result in damage to persons, machines and the
device.
Secure the device against dropping during the entire installation. If necessary, work in pairs
when installing the device.
32
CAUTION
Unified Comfort Panels Hygienic
Compact Operating Instructions, 04/2023, A5E52219907-AA