Installing And Connecting The Device; Preparing For Installation; Checking The Delivery; Checking The Operating Conditions - Siemens MTP700 Unified Comfort Hygienic Compact Operating Instructions

Installing and connecting the device

3.1

Preparing for installation

3.1.1

Checking the delivery

Check the package content for visible signs of transport damage and for completeness.
Note
Damaged parts
A damaged part will cause the HMI device to malfunction.
Do not install parts damaged during shipment. In the case of damaged parts, contact your
Siemens representative.
Check the scope of delivery of the HMI device, see section "Scope of delivery (Page 8)".
Additional documents may be included in the scope of delivery.
The documentation is part of the HMI device and is required for subsequent commissioning.
Keep all enclosed documentation for the entire service life of the HMI device. You must pass
along the enclosed documentation to any subsequent owner or user of the HMI device. Make
sure that every supplement to the documentation that you receive is stored together with the
operating instructions.
3.1.2

Checking the operating conditions

Note the following aspects before installing the device:
1. Familiarize yourself with the standards, approvals, EMC parameters and technical
specifications for operation of the device. This information is available in the following
chapters:
– Labels, certificates and approvals (Page 45)
– Electromagnetic compatibility (Page 49)
– Technical specifications (Page 45)
2. Check the mechanical and climatic ambient conditions for operation of the HMI device in
the following sections:
– Mechanical ambient conditions (Page 51)
– Climatic ambient conditions (Page 52)
3. Observe the notes on local use of the HMI device in section "Notes about usage (Page 16)".
4. Observe the permissible rated voltage: +24 V DC
Unified Comfort Panels Hygienic
Compact Operating Instructions, 04/2023, A5E52219907-AA
3
23