Rack Installation - Eaton 9SX 6000VA Installation And User Manual

3.7

Rack installation

If you ordered other UPS accessories, refer to specific user manuals to check the rack installation
with the UPS.
• Prepare UPS for rack mounting.
This step requires two people.
The UPS is heavy. To ease its rack mounting, you can remove the battery pack from the UPS
as explained below.
1. Remove the center cover of the front panel
2. Remove the two screws to open the left side of the front panel
3. Remove the two screws to pull out the metal protection cover of the battery
A ribbon cable connects the LCD control panel to the UPS. Do not pull on the cable or
disconnect it.
4. Pull out the plastic handle of the battery pack, and slide the pack out slowly on to a flat and stable sur-
face. Use two hands to support the battery pack. Set it aside for reinstalling after that the UPS
is rack mounted.
5. Mount the UPS on rack
6. Put back the battery pack, screw back the metal protection cover and the front panel,
then clip the center cover.
5-6kVA EU_EN
3. Installation
Page 19