Connecting The Ebm(S); Connecting Other Accessories - Eaton 9SX 6000VA Installation And User Manual

3.4

Connecting the EBM(s)

A small amount of arcing may occur when connecting an EBM to the UPS. This is normal and
will not harm personnel. Insert the EBM cable into the UPS battery connector quickly and firmly.
1. Plug the EBM power cable(s) into the battery connector(s). Up to 6 EBMs may be connected
to the UPS.
2. Verify that the EBM connections are tight and that adequate bend radius and strain relief exist for
each cable.
3. Connect the battery detection cable(s) to the connector of the UPS and of the EBM(s).
For easier maintenance please leave 70 cm free space around the EBM.
3.5

Connecting other accessories

If you ordered other UPS accessories, refer to specific user manuals to check the connection
to the UPS.
5-6kVA EU_EN
3. Installation
Page 17