Servicing The Air Cleaner - Toro Greensmaster Flex 1021 Operator's Manual

Hide thumbs Also See for Greensmaster Flex 1021:
Table of Contents

Advertisement

Figure 25
1. Dipstick
3.
Remove the dipstick by rotating it
counterclockwise.
4.
Remove the dipstick and wipe the end clean.
5.
Insert the dipstick fully into the oil-fill tube, but
do not thread it in.
6.
Remove the dipstick and check the engine-oil
level
(Figure
26).
Figure 26
1. Filler tube
2. Dipstick
3. Upper limit
7.
If the engine-oil level is incorrect, add or drain
oil to correct the level; refer to
Engine-Oil Level (page
g266053
2. Drain plug and washer
g019686
4. Lower limit
5. Drain plug
Checking the
23).
Changing the Engine Oil
Service Interval: After the first 20 hours/After the first
month (whichever comes first)
Every 100 hours/Every 6 months (whichever
comes first)
WARNING
Oil may be hot after the engine has been run,
and contact with hot oil can cause severe
personal injury.
Avoid contacting the hot engine oil when you
drain it.
1.
Shut off the engine and wait for all moving parts
to stop; refer to
19).
2.
Place a pan under the drain plug to catch the oil.
3.
Remove the drain plug, washer, and dipstick
(Figure
25).
4.
Position the engine so that the oil drains from
the engine.
5.
When the oil has drained completely, move the
engine to a level position and install the drain
plug and a new washer.
Note:
Dispose of the used oil at a certified
recycling center.
6.
Slowly pour oil into the oil-fill hole until the oil
is at the correct level.
7.
Ensure that the oil is at the correct level on the
dipstick; refer to
(page
23).
8.
Thread the dipstick into the oil-fill hole.
9.
Wipe up any spilled oil.
10.
Connect the wire to the spark plug.

Servicing the Air Cleaner

Service Interval: Before each use or daily
Every 50 hours/Every 3 months (whichever
comes first)
Every 300 hours/Yearly (whichever comes first)
Important:
Do not operate the engine without
the air filter assembly; extreme engine damage
will occur.
1.
Shut off the engine and wait for all moving parts
to stop; refer to
19).
2.
Remove the wingnut securing the air-cleaner
cover
(Figure
3.
Remove the air-cleaner cover.
24
Shutting Off the Engine (page
Checking the Engine-Oil Level
Shutting Off the Engine (page
27).

Advertisement

Table of Contents
loading

This manual is also suitable for:

Greensmaster flex 10180485004860

Table of Contents