Toro Greensmaster Flex 1021 Operator's Manual page 11

Lift-Assist Handle
Use the lift-assist handle
adjusting the handle height or raise and lower the
kickstand.
Handle-Height Adjuster
Use the handle-height adjuster
the handle height to a comfortable operating position.
Pull up on the adjuster and use the lift-assist handle
to raise or lower the handle height.
Figure 10
1. Handle-height adjuster
Choke Lever
The choke lever (Figure
of the engine. Use the lever to aid in starting a cold
engine; refer to Using the Choke Lever (page
1. Choke lever
2. Fuel-shutoff valve
(Figure 9) to help with
(Figure 10) to move
11) is located on the left front
Figure 11
3. Recoil-starter handle
Fuel-Shutoff Valve
The fuel-shut-off valve is located on the side of the
engine below the choke control
Note:
Close the fuel-shutoff valve when the machine
is not used for a few days, during transport to and
from the job site, or when the machine is parked
inside a building; refer to
Fuel-Shutoff Valve (page
Recoil-Starter Handle
Pull the recoil-starter handle
engine.
Kickstand
The kickstand
the machine. Use the kickstand when you install or
remove the transport wheels or the cutting unit.
•
T
RANSPORT
To use the kickstand to install the transport wheels,
put your foot on the kickstand while pulling up and
back on the lift-assist handle
CAUTION
g271081
The machine is heavy and can cause back
strain if lifted improperly.
Put your foot pressure down on the
kickstand and use only the lift-assist
handle to raise the machine. Attempting to
raise the machine onto the kickstand any
other way can cause injury.
16).
•
C
UTTING
To prevent the machine from tipping backward
when removing the cutting unit, lower the kickstand
and push out the spring pin so that it keeps the
kickstand in the position shown in
•
Retracting the kickstand to the S
position:
1. Keep your foot on the kickstand while
lowering the traction drum to the ground.
2. Remove your foot from the kickstand and
allow space for the kickstand to retract to the
S
TORAGE
g265059
11
(Figure
Opening and Closing the
16).
(Figure
(Figure 12) is mounted to the rear of
-W -S position:
HEEL ERVICE
(Figure
-U -S position:
NIT ERVICE
position.
11).
11) to start the
12).
Figure 13.
TORAGE