Casio fx-CG50 User Manual page 492

5. Use f and c to move the highlighting to "Axes" and then use the following operations to
configure the settings you want.
To select this setting:
Show on-screen axes
Hide on-screen axes
Show on-screen axes and scale values
6. After the setting is the way you want, press J.
k Specifying Angle and Length Display Units
You can use the procedure in this section to show or hide the units of angle and length values.
You also can specify which units should be used for angle and length values.
Angle unit: Deg, Rad
Length: mm, cm, m, km, inch, feet, yard, mile
Angle: Rad, Angle Unit: On
u To specify angle and length display units
1. Press !m(SET UP) to display the Setup screen.
2. Perform the following operations to configure the settings you want.
To select this setting:
Degrees for display and
calculation angle unit
Radians for display and
calculation angle unit
Show unit for angle values
Hide unit for angle values
Show unit for length values
Hide unit for length values
3. After the setting is the way you want, press J.
Press this key:
1(On)
2(Off)
3(Scale)
→
Length Unit: On (mm)
Perform this operation:
Highlight "Angle" and then press 1(Deg).
Highlight "Angle" and then press 2(Rad).
Highlight "Angle Unit" and then press 1(On).
Highlight "Angle Unit" and then press 2(Off).
1. Highlight "Length Unit" and then press 1(On).
2. When the dialog box appears, use keys b
through i to specify the length unit.
Highlight "Length Unit" and then press 2(Off).
14-34