Advertisement
List of Parameters
(*)
If GLASS/MODE 2 or GLASS THICKNESS/MODE 2 is selected, a process using multiple tasks will be
performed, as in the multi-task mode.
The following processes are assigned to the respective tasks:
TASK 1
TASK 2
TASK 3
TASK 4
The measurement conditions can be set for each task in this mode.
• Configuration of Task
The ZS-HLDC-N performs task processing.
The processing units for each task are grouped into 20 units.
To refer to the processing unit of TASK N, therefore, add 20×(N-1) to the above pro-
cessing unit No.
Example: To change the averaging process of TASK2, refer to or set to a parameter with:
Unit No.
120
0
1
2
3
121
0
122
2
3
4
5
6
7
8
ZS-HL-N Series
10
Non-procedural Communication Command Reference
Calculates Area 1 displacement value.
Calculates Area 2 displacement value.
GLASS: Calculates the result of the NEAR side of TASK 1 and TASK 2.
GLASS THICKNESS: Calculates the difference value between TASK1 and TASK2.
Unused
Process unit No.=43+20×(2-1)=63 and
Data No.=2
Data No.
Parameter
Hysteresis width
Timer mode
Delay time
Judgment output
TASK
Non-measurement
settings
Monitor focus mode
Monitor focus distance
value 1
Monitor focus distance
value 2
Monitor focus current
value 1
Monitor focus current
value 2
Monitor focus voltage
value 1
Monitor focus voltage
value 2
Setting range/Output range
0 to 999999999 (nm)
0: OFF
1: OFF-Delay
2: ON-Delay
3: One shot
1 to 5000 (ms)
0: TASK 1
1: TASK 2
2: TASK 3
3: TASK 4
0: Keep
1: Clamp
0: OFF
1: ON
-999999999 to 999999999 (nm)
-999999999 to 999999999 (nm)
4 to 20 (mA)
4 to 20 (mA)
-10 to 10 (V)
-10 to 10 (V)
Others
Setting judgment process
Advertisement
