General Specifications - Mitsubishi MELSEC- Q Q12PHCPU User Manual

3 GENERAL SPECIFICATIONS

3 GENERAL SPECIFICATIONS
Item
Operating ambient
temperature
Storage ambient
temperature
3
Operating ambient
humidity
Storage ambient
humidity
Vibration resistance
Shock resistance
Operating ambience
Operating altitude
Installation location
Overvoltage
category 1
Pollution level 2
1 : This indicates the section of the power supply to which the equipment is assumed to be connected
between the public electrical power distribution network and the machinery within premises. Category II
applies to equipment for which electrical power is supplied from fixed facilities.
The surge voltage withstand level for up to the rated voltage of 300 V is 2500 V.
2 : This index indicates the degree to which conductive material is generated in terms of the environment in
which the equipment is used.
Pollution level 2 is when only non-conductive pollution occurs. A temporary conductivity caused by
condensing must be expected occasionally.
3 : Do not use or store the PLC under pressure higher than the atmospheric pressure of altitude 0m.
Doing so can cause a malfunction.
When using the PLC under pressure, please contact your sales representative.
3 - 1
Performance specification of PLC is as follows:
Under
Conforming
intermittent
to
vibration
JIS B 3502,
Under
IEC 61131-2
continuous
vibration
Conforming to JIS B 3502, IEC 61131-2 (147 m/s
Specifications
0 to 55°C
-25 to 75°C
5 to 95%RH, non-condensing
5 to 95%RH, non-condensing
Frequency Acceleration
10 to 57Hz ———
2
9.8m/s
57 to 150Hz
10 to 57Hz ———
2
57 to 150Hz 4.9m/s
2
, 3 times in each of 3 directions X, Y, Z)
No corrosive gases
2000m (6562ft.) max.
Inside control panel
II max.
2 max.
MELSEC-Q
Amplitude Sweep count
0.075mm
(0.003inch)
10 times each in
———
X, Y, Z directions
0.035mm
(for 80 min.)
(0.001inch)
———
3 - 1