Table of Contents
Advertisement
TIMER OPERATION - AVENGER & DYNAMO
CLOCK AND DUAL TIMERS
The setting of the Clock and programming of the Timers is done
via the Set Times button
the appliance through the available clock setting and timer
programming modes that are available.
CHECKING THE CLOCK
One press of the Set Times button
that the clock is set to.
SETTING THE CLOCK
One press of the Set Times button
mode, allowing the current time to be adjusted. When in this
mode the 'Clock' indicator
The factory default clock time is PM 12:00.
Press the Up or Down buttons
desired time.
Pressing and holding either the Up or Down buttons
scroll digits, at first by minute
intervals. When adjusting the time ensure that the correct AM or
PM
setting is observed.
14
To lock in the new clock time and exit the Clock and Timer setting mode without
altering the Timer 1 or Timer 2 settings press the Set Times button
NOTE
PROGRAMMING TIMER 1
Two presses of the Set Times button
'On' programming mode which allows adjustment of the time
when the heater switches 'On' (or starts). The Timer 1 and On
indicators
are illuminated.
20
The factory default Timer 1 'On' time is AM 06:00. Press the Up
or Down buttons
to adjust the Timer 1 'On' time.
13
Pressing and holding either the Up or Down buttons
scroll digits, at first by minute
intervals. When adjusting the time ensure that the correct
15
AM or PM
setting is observed.
14
Pressing the Set Times button
the beginning) selects the Timer 1 'Off' programming mode
which allows adjustment of the time when the heater switches
'Off' (or stops). The Timer 1 and Off indicators
illuminated.
The factory default Timer 1 'Off' time is AM 09:00. Press the Up
or Down buttons
to adjust the Timer 1 'Off' time.
13
Pressing and holding either the Up or Down buttons
scroll digits, at first by minute
intervals. When adjusting the time ensure that the correct
15
AM or PM
setting is observed.
14
To lock in the new Timer 1 on and off timer programs and to exit the Clock setting and
Timer programming mode without altering the Timer 2 settings press the Set Times
NOTE
button
three times, otherwise continue to "PROGRAMMING TIMER 2" on page 13.
18
Rinnai
. Each press of this button will cycle
18
displays the current time
18
selects the clock setting
18
is illuminated
19
to adjust the clock to the
13
intervals and then by hour
17
selects the Timer 1
18
intervals and then by hours
17
again (three presses from
18
intervals and then by hours
17
14
15
will
13
15
14
15
will
13
are
20
14
15
will
13
12
18
18
16
13
17
five times.
18
18
16
13
17
18
16
13
17
Operation Manual
19
20
20
Advertisement
Table of Contents
