Table of Contents
Advertisement
THIS MANUAL MUST BE READ IN ITS
ENTIRETY BEFORE OPERATING HEATER
CONVECTOR VENT-FREE SPACE HEATER
THIS IS AN UNVENTED GAS-FIRED HEATER. IT USES AIR (OXYGEN)
FROM THE ROOM IN WHICH IT IS INSTALLED. PROVISIONS FOR
ADEQUATE COMBUSTION AND VENTILATION AIR MUST BE PROVIDED.
REFER TO INSTALLATION INSTRUCTIONS ON PAGE 8.
WARNING: IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED
EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY
DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS
AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.
• DO NOT TRY TO LIGHT ANY APPLIANCE.
• DO NOT TOUCH ANY ELECTRICAL SWITCH; DO NOT USE ANY
PHONE IN YOUR BUILDING.
• IMMEDIATELY CALL YOUR GAS SUPPLIER FROM A
NEIGHBOR'S PHONE. FOLLOW THE GAS SUPPLIER'S
INSTRUCTIONS.
• IF YOU CANNOT REACH YOUR GAS SUPPLIER, CALL THE
FIRE DEPARTMENT.
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED
INSTALLER, SERVICE AGENCY OR THE GAS SUPPLIER.
INSTALLER:
MUST LEAVE MANUAL WITH UNIT AFTER INSTALLATION.
OWNER: RETAIN THIS MANUAL SAFELY, FOR FUTURE REFERENCE.
HOME OWNER/INSTALLER
FOR YOUR SAFETY
RCE-229A
SILENT SERVANT
Owner's Operation and Installation Manual
WHAT TO DO IF YOU SMELL GAS
Advertisement
Table of Contents
Related Manuals for Rinnai RCE-229A
Summary of Contents for Rinnai RCE-229A
-
Page 1: For Your Safety
HOME OWNER/INSTALLER FOR YOUR SAFETY THIS MANUAL MUST BE READ IN ITS ENTIRETY BEFORE OPERATING HEATER RCE-229A SILENT SERVANT CONVECTOR VENT-FREE SPACE HEATER Owner’s Operation and Installation Manual THIS IS AN UNVENTED GAS-FIRED HEATER. IT USES AIR (OXYGEN) FROM THE ROOM IN WHICH IT IS INSTALLED. PROVISIONS FOR ADEQUATE COMBUSTION AND VENTILATION AIR MUST BE PROVIDED. -
Page 2: Table Of Contents
A N Y A LT E R AT I O N O F T H E O R I G I N A L D E S I G N I N S TA L L E D O T H E R THAN AS SHOWN IN THESE INSTRUCTIONS OR USED WITH A TYPE OF GAS NOT SHOWN ON THE RATING PLATE, IS THE RESPONSIBILITY OF THE PERSON AND COMPANY MAKING THE CHANGE. www.rinnaina.com Model RCE-229A... -
Page 3: Specifications
Power Failure In the event of a power failure or power cut, the gas valves will automatically close. After the power is re-instated the appliance must be restarted manually. Model RCE-229A 800-621-9419... -
Page 4: Important Points
8. This heater can be installed in a bathroom or a bedroom. When installed in a bathroom or a bedroom, the heater must be wall mounted with optional wall mounting kit. See page 26 of manual for part No. of wall mounting kit. www.rinnaina.com Model RCE-229A... -
Page 5: Safety Points
Do not allow children or elderly persons to Do not sit on this heater. sleep in the warm air discharge from the heater. Model RCE-229A 800-621-9419... - Page 6 Do not place containers of liquid on top of Combustible materials must not be placed the heater. Water in the heater can cause where the heater could ignite them. extensive damage. Do not place articles in front of the hot air discharge. www.rinnaina.com Model RCE-229A...
-
Page 7: Usage And Installation Musts
Some carpets contain dyes which can be effected by warm air flow and could discolor. To aid in prevention of discoloration, place a mat under the unit to extend to the front 30 “. Model RCE-229A 800-621-9419... - Page 8 WARNING: If the area in which the heater may be operated is smaller than that defined as an unconfined space or if the building is of unusually tight construction, provide adequate combustion and ventilation air by one of the methods described in the National Fuel Gas Code, ANSI Z223.1, Section 5.3 or applicable local codes. www.rinnaina.com Model RCE-229A...
-
Page 9: Installation Instructions
2. A shut off valve (or appliance connector valve) should be installed in the upstream of the gas line to permit servicing. 3. Flexible pipe and any appliance connector valve used for gas piping shall be types approved by nationally recognized agencies. Model RCE-229A 800-621-9419... - Page 10 Z21.11.2. Valve is packaged with unit. MANUAL VALVE CLOSED OPEN After completing pipework, secure the heater to the floor. Use the two screws provided, as shown in the drawing. To prevent deforming base plate, do not over torque screws. www.rinnaina.com Model RCE-229A...
-
Page 11: Operating Instruction Plate
I N S T A L L A T I O N I N S T R U C T I O N S OPERATING INSTRUCTION PLATE CONVECTOR RCE-229A FOR YOUR SAFETY READ BEFORE OPERATING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. -
Page 12: Additional Customer Operating Information
I n d i c a t e s F u n c t i o n l o c k Locks all controls when i s a c t i v a t e d . pressed. (Except OFF) www.rinnaina.com Model RCE-229A... - Page 13 OFF to maintain the selected room temperatures. When the AUTO-OFF indicator is not glowing, you have selected a manual off mode of operation. The unit will continue to produce at least 2000 BTU/h of heat until you cut the unit off manually. Model RCE-229A 800-621-9419...
- Page 14 OFF switch will be locked. Deactivating the lock releases the controls. If the lock is activated while the heater is turned OFF, then all functions will be locked. If the heater is turned OFF while the Function Lock is activated, it cannot be turned ON again until the lock is deactivated. www.rinnaina.com Model RCE-229A...
- Page 15 These times can be selected in 30 minute increments up to 10 hours and then 1 hour increments up to the maximum of 24 hours. BEFORE SELECTING THE ON TIMER CONFIRM: That the desired preset room temperature has been set (see page 13) Model RCE-229A 800-621-9419...
- Page 16 ON Timer setting is cancelled. “00” will flash on the digital monitor when power is reinstated. Pressing the ON button and starting the unit will delete the “00”. www.rinnaina.com Model RCE-229A...
-
Page 17: Maintenance / Service
Make a careful visual inspection of all electrical connection and wiring. STEP 2: If the trouble persists after checking step 1, please check the cause of trouble in the following trouble shooting chart and correct it by following the procedures shown. Model RCE-229A 800-621-9419... -
Page 18: Trouble Shooting Chart
Clean the air filter (weekly) Louver Obstructed Clean obstruction Air Filter Blocked Clean filter (weekly) Gas Escape Service call ON Timer is Set Cancel ON Timer Function Lock Set Cancel Function Lock Gas Turned Off at Meter Turn gas on www.rinnaina.com Model RCE-229A... -
Page 19: Schematic Drawings/Parts List
S C H E M A T I C D R A W I N G S Wiring Diagram Model RCE-229A 800-621-9419... - Page 20 S C H E M A T I C D R A W I N G S Cabinet - Exploded View www.rinnaina.com Model RCE-229A...
- Page 21 S C H E M A T I C D R A W I N G S Gas Valve/Burner Assembly - Exploded View Model RCE-229A 800-621-9419...
- Page 22 S C H E M A T I C D R A W I N G S Fan Blower Assembly - Exploded View www.rinnaina.com Model RCE-229A...
- Page 23 S C H E M A T I C D R A W I N G S Electrical Wiring - Exploded View Model RCE-229A 800-621-9419...
- Page 24 113-2 SCREW ZFAB0408SZ ELECTRODE RC-328-32-2 115-1 ELECTRODE BRACKET RC-334-136 115-2 SCREW ZFAB0408SZ SILICON TUBE RC-223-84-b 117-1 COMBUSTION CHAMBER COVER RC-219-31 117-2 SCREW ZFAB0408SZ 118-1 COMBUSTION CHAMBER COVER LID RC-352-29 118-2 SCREW ZFAB0408SZ HEAT SHIELD RC-219-35 SEPARATION BOARD RC-219-37 www.rinnaina.com Model RCE-229A...
- Page 25 700-3 SCREW ZGAA0308SZ ZFAB0410SZ 700-4 SCREW 700-5 IGNITER ASS'Y EI-181-1 CP-30421-1 700-6 SCREW 701-1 SUB P.C.B. ED-189 EP-102-13 250V 3A 701-2 CURRENT FUSE 701-3 SCREW CP-30421-1 RC-229-530 TF HARNESS 703-1 POWER SUPPLY CORD CP-90466-1 703-2 SCREW CP-30421-1 Model RCE-229A 800-621-9419...
- Page 26 RC-229-517 711-2 SCREW ZGAA0308SZ OWNER'S INFORMATION MANUAL RC-229-521 RATING PLATE RC-229-527-1 RATING PLATE RC-229-527-2 CAUTION PLATE RC-229-525 OPERATING PLATE RC-229-538 WIRING DIAGRAM RC-229-520 ANCHOR AU 102-902 SCREW CP-30408 MANUAL VALVE ASS'Y BRR37-244 WALL BRACKET KIT (OPTION) RC-229-550 www.rinnaina.com Model RCE-229A...
-
Page 27: Error Messages
Turn heater OFF, Power cut then ON again. If you see other codes displayed, contact Rinnai or your nearest service agent and arrange for a service call. In all cases, you may be able to clear the Error Message simply by turning the heater OFF, then ON again. -
Page 28: Limited Warranty
Any such warranty replacement or repair shall be subject to the terms and conditions of this warranty for the remainder of the original period of coverage. In order to obtain the name and location of the qualified Rinnai servicing agent closest to you, please write Rinnai at the address shown on the back side of the warranty card or call Rinnai at 1-800-621-9419.