Table of Contents
Advertisement
HOW TO OPERATE THE HEATER
Avenger, Dynamo
* Enduro
TO TURN THE HEATER ON
Before you begin, ensure that the Gas and Power have been connected correctly to the appliance.
To turn the appliance on press the ON/OFF button
are equipped with a remote control the ON button
When pressed the appliance will begin to operate in the following factory preset manner:
•
The default set temperature will be 22° C
•
The current room temperature will be displayed
•
The ON/Combustion indicator
The ON/Combustion indicator will change to Red (steady) after proper ignition has been
achieved to signify the correct burner operation.
When using the appliance for the first time or after long periods of disuse, ignition may
not occur the first time it is operated as there may be air within the pipes. If ignition
NOTE
does not occur after approximately 30-seconds the unit will cease operation
automatically. If this occurs press the ON/OFF button
that are equipped with a remote control the press the STANDBY button
press the ON button
The unit may make noises after ignition/extinction. This is due to expansion and
contraction of the heater components and is normal.
The heater will not immediately ignite if the ON/OFF button
extinction. After approximately 20 seconds has passed, the heater will automatically
go into ignition mode.
TO ADJUST SET TEMPERATURE
The "SET" temperature may be raised or lowered by use of the Up and Down buttons
the control panel. For models that are equipped with a remote control the Up and Down buttons
may also be used.
The following "SET" temperatures can be selected.
•
'L' for continuous combustion on lowest burner setting.
•
Adjustable temperature setting between 16º C to 26º C in 1º C steps. Gas consumption will adjust
automatically to help maintain the "SET" temperature.
•
'H' for continuous combustion on highest burner setting.
Once the temperature is set it will be stored in the microcomputers memory, if the temperature is not
adjusted further it will be available as the initial setting when the appliance is next used.
Rooms may not arrive at the "SET" temperature due to the size and construction of
the room, location of the appliance or external temperatures.
NOTE
If the appliance burner does not ignite then the room temperature may be higher than
the "SET" temperature.
* Remote Control not available with this model.
Rinnai
28
22
24
26
27
21
23
25
14
15
28
38
36
32
27
37
35
34
33
.
15
will illuminate Green (steady). Ignition will take 5 ~ 10 seconds.
12
to restart.
39
10
30
29
19
12
18
16
13
20
17
30
29
12
31
13
located on the control panel. For models that
2
may also be used.
39
,
/
17
31
33
twice to restart. For models
2
2
40
39
41
2
2
and then
40
is pressed straight after
located on
13
41
Operation Manual
Advertisement
Table of Contents
