OPERATION
For trouble free operation, please read the following information carefully.
For your convenience the controls on your new Spectrum 28 are situated under the cover on the top right hand
side of the heater.
All necessary adjustments to the operation of your Spectrum 28 can be made with these controls.
IGNITION
Press the first (low and Ignition) button firmly, this operates the built in safety device and starts the electronic spark,
the centre burner will ignite. Check that the burner has lit, continue to hold the button down for about 15 seconds.
The spark will continue whilst the button is held down.
Release the button.
If the burner does not remain alight, push the button again and release it, this will return it to the "OFF" position.
Wait 30 seconds, then repeat the ignition procedure.
(The ignition button must be in the "OFF" position before attempting re-ignition).
After ignition the heater is at its lowest setting with one burner alight.
Rinnai
12
REH281 - SPECTRUM 28 OIM