Connext Setup - Other Bluetooth Devices - Garmin GTN 625 Reference Manual

Connext Setup - Other Bluetooth Devices

The GTN can also configure the Bluetooth transceiver in other units, such
as the GTX 345.
Touch to set
the Bluetooth
name.
From the Connext Setup page, the pilot can enable/disable Bluetooth,
change the Bluetooth name, and manage paired devices. On the Paired
Devices page, the device status indicates if the portable device is paired and
connected. To connect a different device when the maximum number are
already connected, the existing connection must be ended by removing the
portable device pairing or by disconnecting or disabling Bluetooth on the
portable device. Removing a device from this page by pressing "Remove" will
require the device to be paired again before reconnecting.
NOTE: If the pairing is removed from either device (portable device or
installed avionics) it must be removed on the other device before a new
pairing to that same device is established again. Essentially, the pairing
must be removed on both devices before re-pairing.
New devices can only be paired while the unit is in "Pairing Mode." Pairing
mode is active while on the Connext Setup page or the Manage Paired Devices
page. The pairing must be initiated by the portable device. A pop-up will be
displayed on the portable device to confirm the pairing.
48
Connext Setup for GTX 345
GTN 625/635/650 Cockpit Reference Guide
Touch to enable
Bluetooth.
Touch to manage
paired devices.
190-01004-04 Rev. N