Setting The Power Saving Mode - Philips ESP 2 User Manual

Setting the Power Saving Mode

This function saves battery power by adjusting the LCD monitor brightness. MODE 1,
MODE 2, or MODE 3 can be set. However, the operations vary depending on whether
the record mode and playback mode is set. Figure 57-1
Power saving mode
OFF
MODE1
MODE2
MODE3
To select a power saving mode, follow these steps.
q Press the +/– button while pressing the U U U U U
button, and the T T T T T button at the same time.
The REC(ord)/PLAY switch may be set to either
REC or PLAY.
The power saving setting mode is set.
w Press the U U U U U or T T T T T button to select the power
saving mode.
In three seconds, the power saving mode will be
set.
To cancel the setting
Repeat the operation described above, selecting
OFF at step 2.
Record mode
Regular operation
The LCD monitor is slightly dark.
This condition remains until the setting is
changed.
The LCD monitor becomes dark. If the Re-
lease button is pressed lightly, the LCD
monitor returns to the regular brightness.
When the Release button is pressed and re-
leased, the picture is taken and the LCD
monitor turns dark again after a few seconds.
The LCD monitor becomes dark. If the Re-
lease button is pressed lightly, the LCD
monitor becomes slightly dark.
When the Release button is pressed and re-
leased, the picture is taken and the LCD
monitor turns dark again after a few seconds.
Playback mode
Regular operation
T h e L C D m o n i t o r i s
slightly dark.
This condition remains un-
til the setting is changed.
This setting can be oper-
ated, however, the power
saving function cannot be
operated.
Same as MODE 1.
DATE
3
4
5
57