Tungsten Light Mode
Use the Tungsten Light mode when shooting a picture in incandescent lighting or when
the Auto White Balance does not work properly.
q When the REC(ord)/PLAY switch is set to
REC, press the FLASH button while press-
ing the U U U U U button.
w Within three seconds, press the U U U U U or T T T T T
button to display the
monitor.
The
will remain on the LCD monitor for about
three seconds.
Important
• The Flash Off mode is set when the Tungsten Light mode is set. At this time, the Flash mode
cannot be switched, even if the FLASH button is pressed.
• The color tone for the same subject may vary depending on the type of incandescent light.
Canceling the Mode
Press the FLASH button while pressing the U button. Within three seconds, press
the U or T button to select AUTO.
symbol on the LCD
DATE
43
3