Table of Contents
Advertisement
www.ti.com
The INPUT/OUTPUT MAPPING section allows the user to remap the analog input channels to any of the
digital output channels. The implementation in silicon allows for all combinations of mapping. However,
because each combination requires a unique firmware or DLL configuration, the GUI limits the number of
combinations available in mapping. To un-grey and enable this section check the ENABLE MAPPING
checkbox as shown in
Figure 68. INPUT/OUTPUT MAPPING with EN_INTERLEAVE = 0
The default state of this section shows that output channels 1–4 have mapped the signal that is sampled
at analog input channel 1, while channels 5–8 have mapped the signal that is sampled at analog input
channel 8. This menu applies if interleaving is disabled. If interleaving is enabled on the Top Level tab,
then the mapping options reflects this as shown in
Figure 69. INPUT/OUTPUT MAPPING with EN_INTERLEAVE = 1
The remaining sections of the Digital Signal Processing tab are straightforward and explained by the info
buttons provided.
5.5
Channel Filter Tab
The last tab is Channel Filter and contains the controls for the decimation filters as well as the integrated
high pass filters. As shown in
implementation.
SLAU491 – May 2013
Submit Documentation Feedback
Figure
68.
Figure
70, the controls have interdependencies, reflecting the actual silicon
ADS5296, 4-Channel 200-MSPS, and 8-Channel 80-MSPS, Analog-to-Digital
Copyright © 2013, Texas Instruments Incorporated
Figure
69.
ADS5296 GUI in Detail
Converter Evaluation Module
61
Advertisement
Table of Contents
