Backlapping The Cutting Unit - Toro Greensmaster eFlex 1018 Operator's Manual

Bedknife Grinding Specifications
Figure 26
1. Relief angle
2. Top face
3. Remove burr
Standard bedknife relief angle
Extended bedknife relief angle
Front Angle Range
Checking the Top Grind Angle
The angle that you use to grind your bedknives is
very important.
Use the angle indicator (Toro Part No. 131-6828) and
the angle-indicator mount (Toro Part No. 131-6829) to
check the angle that your grinder produces and then
correct for any grinder inaccuracy.
1. Place the angle indicator on the bottom side of
the bedknife as shown in
Figure 27
1. Bedknife (vertical)
2. Press the Alt Zero button on the angle indicator.
3. Place the angle-indicator mount on the edge
of the bedknife so that the edge of the magnet
mates with the edge of the bedknife
Note:
The digital display should be visible from
the same side during this step as it was in step 1.
g032182
4. Front face
5. Front angle
3° minimum
7° minimum
13° to 17°
Figure 27.
g034113
2. Angle indicator
(Figure 28).
1. Angle-indicator mount
2. Edge of the magnet mated
with the edge of the
bedknife
4. Place the angle indicator on the mount as shown
in Figure 28.
Note:
This is the angle that your grinder
produces, and should be within 2 degrees of the
recommended top grind angle.
Backlapping the Cutting
Unit
To backlap the cutting unit, use the Access Backlap
Kit (Model No. 139-4342); refer to the operating
instructions in the kit Installation Instructions. Contact
your authorized Toro distributor to acquire this kit.
16
Figure 28
3. Bedknife
4. Angle indicator
g034114