Figure 15
1. Gauge bar
3.
Rotate the adjusting screw until the roller
contacts the front of the gauge bar.
4.
Repeat steps
2
and for the left side.
5.
Adjust both ends of the roller until the entire
roller is parallel to the bedknife.
Important:
When set properly, the rear and
front rollers contact the gauge bar and the
screw is snug against the bedknife. This
ensures that the height of cut is identical at
both ends of the bedknife.
6.
Tighten the locknuts on the height-of-cut arms
to secure the adjustment enough to remove play
from the washer.
7.
Verify that the height-of-cut setting is correct;
repeat this procedure if necessary
Adjusting the Clip Rate
The clip rate is determined by the following machine
settings:
•
Reel speed: The reel speed can be adjusted to
a high or low setting; refer to your traction unit
Operator's Manual.
•
Reel-drive-pulley position: The reel-drive pulleys
(22-tooth and 24-tooth) can be set in 2 positions:
g016945
– H
position: "A" in
IGH
– L
position: "B" in
OW
Note:
The pulley position is set to the L
position from the factory.
1. Pulley (24 tooth)
To adjust the position of the pulleys, refer to the
following steps:
1.
Remove the belt cover to expose the belt
17).
11
Figure 16
Figure 16
Figure 16
2. Pulley (22 tooth)
OW
g310843
(Figure