Table of Contents
Advertisement
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Media and Additional Parts
Description
Operator's Manual
Parts Catalog (not included)—refer to the
included postcard for information on obtaining
the Parts Catalog
Note:
Determine the left and right sides of the
machine from the normal operating position.
1
Inspecting the Cutting Unit
Parts needed for this procedure:
1
Cutting unit
Procedure
After the cutting unit is removed from the box, inspect
the following:
1.
Check each end of the reel for grease.
Note:
Grease should be visibly evident in the
internal splines of the reel shaft.
2.
Ensure that all nuts and bolts are securely
tightened.
3.
Make sure that the carrier-frame suspension
operates freely and does not bind when moved
back and forth.
Description
Cutting unit
No parts required
No parts required
Straight grease fitting
O-ring
Qty.
1
–
–
1
1
Qty.
1
Review the material and save it in an appropriate place.
–
2
Using the Kickstand
No Parts Required
Procedure
Whenever the cutting unit has to be tipped to expose
the bedknife/reel, prop up the rear of the cutting unit
with the kickstand (supplied with the traction unit) to
make sure that the nuts on the back end of the bedbar
adjusting screws are not resting on the work surface
(Figure
3).
5
Use
Inspect the cutting unit.
Use the kickstand when tipping the
cutting unit.
Adjust the rear shield.
Install the loose parts.
Use
Advertisement
Table of Contents
