Table of Contents
Advertisement
Q5.
How do I acquire the latest software
updates?
1. Software is available on-line. Please visit https://www.ia.omron.com/, then
locate your appropriate regional site from the Global Network panel. Once at
your local site, search for "LVS-95XX Software."
2. Follow the instructions to download the software. Save the software and unzip
the extract files prior to installing. You MUST install the software with
administrative rights. Close any version of the 95XX software that is currently
running and disconnect the LVS-95XX unit from the USB port.
3. Prior to installation, copy your LVS-95XX.MDB (the path can be found on the
"Archive" tab "Change SQL Connection" button Data Source). Save the
file to place back into the specified folder when complete. If you do not save off
your LVS-95XX.MDB file, you will be prompted when opening the software to
perform a factory calibration or that factory calibration is not found.
4. Double-click on "setup exe" to install the software and follow the prompts
accordingly.
5. After installation is complete, connect the USB to your LVS-95XX system.
Right-click on the LVS-95XX icon and run as an administrator.
6.
Q6.
Why are letter grades no longer shown in the
grading results for software version 4.3 and
later?
The letter grade is not used as part of the normative standards of ISO 15416, and
the informative table D.1 that has a letter grade reference is not consistent with
the 15416:2016 ranges of values for scan reflectance profile values shown in the
standards. Some barcodes will receive higher scores due to the changes in ISO
15416:2016 when graded with version 4.3 and later software compared with
earlier versions of LVS-95xx software. ISO 15415 also defines that symbol grade
shall be reported as a numeric value with decimal. For consistency purposes
version 4.3 will also no longer report a letter grade for 2D symbols.
Q7.
My code is graded as "0" and the following
message appears: "Required <FNC1> not
found." Why is it that when I switch
application standards to ISO/IEC
15415/15416, I do not receive the error
message?
<FNC1> is a special character reserved for GS1-compliant symbols when using
Code 128, QR code or Data Matrix. If "GS1 General Specifications" is selected as
the Application Standard on the "Setup" tab, and FNC1 is not encoded in the first
position of the code, the code will automatically be graded an "0" since it is not
GS1 compliant. If the code is intended to be GS1 compliant, notify the originator
that ISO/IEC 15415/15416 does not require that FNC1 be present. If you are not
LVS-95XX Frequently Asked Questions
Page 8 of 17
Advertisement
Table of Contents
