Removing A Controller From The Riser Module; Concluding Steps - Fujitsu PRIMERGY CX2550 M2 Upgrade And Maintenance Manual

6.3.2.2

Removing a controller from the riser module

Figure 30: Removing a controller from the riser module
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section
brackets" on page
Ê Pull the controller out of the riser card connector (1).
I
Make sure that the metal pin of the controller bracket does not get
stucked with the recess of the riser bracket (see circle).
6.3.2.3

Concluding steps

Perform the following procedures:
"Installing the riser module" on page 43
Ê
"Installing the server node in the server enclosure" on page 50
Ê
Ê Reconnect all external cables.
CX2550 M2
95.
Upgrade and Maintenance Manual
"Mounting expansion card slot
Expansion cards
111