Replacing The Led Control Board - TYAN Transport GX18 Service Engineer's Manual

3.3.2 Replacing the LED Control Board

Follow these instructions to replace the LED board.
1. Remove all the cables connected to the LED board,
including USB, LED board, and LED board power cables
(1: LED board power cable, 2 & 3: LED board cable, 4:
USB cable
2. Release the four screws to take off the LED board. After
done, follow the reverse procedures as above to install
the LED board.
Chapter 3: Replacing Pre-Installed Components
)
2
3
4
2
1
33