Interface In The User Program (Status Of Blocks) - Siemens SIMATIC NET S7-300-PROFIBUS CP 342-5 Equipment Manual

Configuration and operation

4.4 Interface in the user program (status of blocks)

4.4 Interface in the user program (status of blocks)
Status displays with the program block AG_SEND
For the CP 342-5 (6GK7 342-5DA03-0XE0), note the following over and above the
information in /4/ (Page 54), Release 03/2010:
DONE ERROR
0 1
Status displays with the program block DP_DIAG
For the CP 342-5 (6GK7 342-5DA03-0XE0), note the following over and above the
information in /4/ (Page 54), Release 03/2010:
DONE ERROR STATUS
1 0 0000
1 0 8248
40
STATUS Meaning
8315 Possible additional meaning:
H
This error code can also occur with bus problems (for example physical disturbances
due to bad cable connections or different settings for the transmission speed on the
nodes).
Possible Meaning
with DTYPE
0, 1 Job completed without error
H
and 4-9
Note:
With DTYPE 2, 3 and 10, error-free execution is indicated by a status code
other than "0". Below (see table DP_DIAG codes in /4/ (Page 54)), you will
see the detailed status codes for error-free execution for the range:
82XX
If an error occurs in execution, you receive status codes in the following
ranges:
80XX
2, 3, 10 Job completed without error
H
Note: This is the default code for the named diagnostics types if there is
no special situation to signal.
H
, 83XX , 8FXX
H H H
Equipment Manual, 01/2023, C79000-G8976-C146-11
CP 342-5