Pushing The Machine By Hand - Toro TimeCutter HD MyRide Operator's Manual

and loss of control. Reduce the towed weight and
slow down.
•
Stopping distance increases with the weight of the
towed load. Travel slowly and allow extra distance
to stop.
•
Make wide turns to keep the attachment clear of
the machine.
Pushing the Machine by
Hand
Important:
Always push the machine by hand. Do
not tow the machine, because damage may occur.
This machine has an electric-brake mechanism, and
to push the machine, the ignition key must be in the
position. The battery needs to be charged and
RUN
functioning for the electric brake to be disengaged.
Pushing the Machine
1. Park the machine on a level surface, and
disengage the blade-control switch.
2. Engage the parking brake, shut off the engine,
and wait for all moving parts to stop before
leaving the operating position.
3. Locate the bypass levers on the frame on both
sides of the engine.
4. Move the bypass levers forward through the key
hole and down to lock them in place
Note:
Do this for each lever.
5. Disengage the parking brake.
Note:
Do not start the machine.
Figure 33
1. Bypass lever
2. Lever position for
operating the machine
6. When finished, engage the parking brake.
(Figure 33).
g298692
3. Lever position for pushing
the machine
Operating the Machine
Move the bypass levers rearward through the keyhole
and down to lock them in place as shown in
Note:
Do this for each lever.
30
Figure 33.