Advertisement
Quick Links
TimeCutter
Loose Parts
Note: Use the chart below to verify that all parts have been shipped.
Description
Bolt, 1/4 x 3/4 inch
Washer, 1/4 inch
Nut, 1/4 inch
Seat
Spacer
Knob
Flat washer, 5/16 inch
Left-hand control lever
Right-hand control lever
Bolt, 3/8 x 1 inch
Curved washer, 3/8 inch
Hose coupling
Key
Operator's Manual
Engine Operator's Manual
Registration card
Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
W 2004 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
)
ZX Riding Mowers
Qty.
Use
2
2
Installing the battery
2
1
2
Installing the seat
2
2
1
1
Installing the motion control levers
4
4
1
Washing the underside of the mower
1
1
Read before operating the machine.
1
1
Fill out and return to Toro.
Original Instructions (EN)
Form No. 3353-782 Rev A
Setup Instructions
Contact us at www.Toro.com
All Rights Reserved
Printed in the USA
Advertisement
Related Manuals for Toro TimeCutter ZX
Summary of Contents for Toro TimeCutter ZX
- Page 1 Washing the underside of the mower Operator’s Manual Read before operating the machine. Engine Operator’s Manual Registration card Fill out and return to Toro. Warning CALIFORNIA Proposition 65 Warning Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm.
- Page 2 Installing the Battery 4. Wait five to ten minutes after filling the battery cells. Add electrolyte, if necessary, until the electrolyte level is up to the Upper line (Fig. 1) on the battery case. Bulk electrolyte with 1.260 specific gravity must be purchased from a local battery supply outlet.
- Page 3 2. Place the levers (with the mounting plates toward the 2. Remove the knobs and flat washers (5/16 inch) from the rear of the machine) on the outside of the control arm seat support. shaft and loosely secure them with the 4 bolts and 3.
- Page 4 Washing the Underside of the Mower A hose coupling is included in loose parts for washing the underside of the mower. See the Operator’s Manual for the proper procedure. Checking the Mower Adjustment The mower deck was leveled at the factory. If the mower is not cutting level, adjust the side-to-side level and the front-to-rear blade slope.