Adjusting The Anti-Scalp Rollers - Toro TimeCutter HD MyRide Operator's Manual

3. Select a hole in the height-of-cut system
corresponding to the desired height of cut and
insert the pin (Figure
4. Push on the deck-lift pedal with your foot and
pull the handle rearward to disengage the
transport lock (Figure
5. Lower the deck slowly until the lever makes
contact with the pin.
Figure 28
1. Deck-lift pedal
2. Handle
28).
27).
3. Pin
4. Height-of-cut positions
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the
height of the anti-scalp rollers.
Note:
Adjust the anti-scalp rollers so that the rollers
do not touch the ground in normal, flat mowing areas.
1. Park the machine on a level surface, disengage
the blade-control switch and engage the parking
brake; refer to
(page 20).
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Adjust the anti-scalp rollers as shown in
29.
g188850
1. Anti-scalp roller
2. Spacer
3. Bushing
26
Engaging the Parking Brake
Figure 29
4. Flange nut
5. Bolt
Figure
g029955