Table of Contents
Advertisement
5. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
NOTE:
Ensure to route the speaker cable over the WLAN antenna cables.
6. Connect the display cable to the connector on the system board.
Next steps
1. Install the
wireless
card.
2. Install the
M.2 2230 solid state drive
3. Install the
base
cover.
4. Install the
SD
card.
5. Follow the procedure in
Removing the aluminum display assembly
CAUTION:
The information in this section is intended for authorized service technicians only.
CAUTION:
The maximum operating angle for the display-panel hinge is 135 degrees.
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
or
M.2 2280 solid state drive
After working inside your
Before working inside your
(whichever applicable).
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
85
Advertisement
Table of Contents
