Table of Contents
Advertisement
About this task
The following images indicate the location of the discrete heat sink and provide a visual representation of the installation
procedure.
Steps
1. Place the heat sink on the system board.
2. Replace the three (M2x3) and tighten four captive screws that secure the heat sink to the system board.
NOTE:
Replace and tighten the screws in the sequential order mentioned on the heat sink [7>6>5>4>3>2>1].
NOTE:
The number of screws varies depending on the configuration ordered.
Next steps
1. Install the
base
cover.
2. Install the
SD
card.
3. Follow the procedure in
I/O daughter board FFC
Removing the Input/Output daughter board FFC
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
4. Remove the fan.
74
Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
computer.
computer.
Advertisement
Table of Contents
