Advertisement
5. Fill the hydraulic tank with hydraulic fluid until the
fluid overflows the filter and then turn it clockwise until
the rubber gasket contacts the filter adapter, then tighten
the filter an additional 1/2 turn (Fig. 25).
6. Clean up any spilled fluid.
7. Add fluid to the cold level of the baffle in the hydraulic
tank (Fig. 26). Do not overfill.
1
2
4
Figure 26
1. Cap
2. Baffle
8. Clean the area filler neck of hydraulic tank.
9. Install cap on filler neck.
Restart Original Maintenance Schedule
After changing the hydraulic fluid or working on the
system, it is necessary to restart the maintenance schedule.
This includes changing the hydraulic fluid after the first 8
hours of use. Refer to the Maintenance Section in your
Operator's Manual for more information.
3
m–5615
3. Cold fluid level—full
4. Hot fluid level—full
10
Installing the Rear Wheels
1. Mount the wheels with the valve stem to the outside and
secure it with the nuts previously removed (Fig. 27).
Note: Most units have nuts securing the wheel to the unit;
however, some older models have bolts in place of the nuts.
2. Torque the nuts to 95 ft-lb (128 N m).
Figure 27
Right wheel shown
1. Wheel nuts
1
2
m–6917
2. Left rear wheel
Advertisement
