Advertisement
Rerouting the Hydraulic Pump Lines
The hydraulic lines that connect the pump to the tank need
to be rerouted to reach the new tank position.
1. Loosen the swivel nuts of the threaded elbow
connections at both the left and right pumps and
disconnect the hydraulic lines (Fig. 10).
4
2
Figure 10
1. Hydraulic pump line
2. T-connection, old location
3. T-connection, new
location
4. Hydraulic tank
Important
Do not disconnect the hydraulic lines at the
T–connection.
1
3
6
5
m–7155
5. Threaded connection,
right pump
6. Threaded connection, left
pump
2. Flip the hydraulic line assembly, as shown in
figures 10 and 11, so the lines reach the new tank
location.
After
Figure 11
3. Connect the hydraulic lines to the respective pumps
(Fig. 11).
4. Connect the remaining hydraulic line to the hydraulic
tank.
Installing the New Hydraulic Line
1. Locate the swivel head hydraulic line assembly, for
model year 2001 and before, and apply thread sealer
tape to the pipe thread end of the line (Fig. 12).
2
Figure 12
1. Hydraulic line assembly,
model year 2001 and
before
2. Connect the pipe thread end of the new hydraulic line
assembly to the hydraulic filter bracket.
3. Route the new line around the engine and to the
hydraulic tank (Fig. 13).
5
m–7156
Before
3
1
m–7167
2. Swivel head end
3. Pipe thread end
Advertisement
