Advertisement
11. Remove the hydraulic tank cap and flush out the empty
tank to remove any foreign debris.
12. Replace the tank cap.
Installing the Hydraulic Tank
A hole must be drilled in the left engine guard to
accommodate the new tank stand. Use the tank stand to
mark the location of the drill hole.
1. Install the tank stand upside down to the left engine
guard as shown in figure 7, using a bolt (5/16 x 1 inch)
and a flange nut (5/16 inch).
Important
Verify the rear bolt hole is used when
attaching the tank stand (Fig. 7).
3
6
1
5
Figure 7
1. Tank stand, upside down
2. Left engine guard
3. Bolt, 5/16 x 1 inch
2. Use a center punch to mark the location of the second
hole to be drilled.
3. Remove the tank stand and fasteners. Set them aside for
later use.
4. Drill a hole in the engine guard, 5/16 inch in diameter,
at the point marked previously (Fig. 7).
2
4
m–7145
4. Flange nut, 5/16 inch
5. Rear bolt hole
6. Drill point
5. Install the tank stand in the upright position as shown in
figure 8, using one bolt (5/16 x 1 inch), one bolt
(5/16 x 3/4 inch), and two flange nuts (5/16 inch).
3
2
Figure 8
1. Tank stand, upright
position
2. Bolt, 5/16 x 1 inch
6. Position the hydraulic tank assembly on the tank stand,
lining up the newly drilled holes to the tank stand posts
(Fig. 9).
3
1
2
Figure 9
1. Tank assembly
2. Tank stand post
3. Drilled holes
7. Install the tank to the tank stand using two bolts
(1/4 x 1 inch) and two washers (1/4 inch) as shown in
figure 9.
4
1
4
5
m–7146
3. Bolt, 5/16 x 3/4 inch
4. Flange nut, 5/16 inch
5. Drilled hole
4
5
m–7160
4. Bolt, 1/4 x 1 inch
5. Washer, 1/4 inch
Advertisement
