Table of Contents
Advertisement
Available languages
Available languages
Contents
1
Safety notes
2
Mechanical mounting
2.1
Mounting to linear actuators
2.1.1 Preparation of the valve actuator
sensor (only for version with
2.2
3
4
4.1
potentiometer (code S01)
5
5.1
Electrical and pneumatic
connection
5.2
Automatic initialisation
5.3
Commissioning
6
Information
1
Safety notes
Please refer to the safety notes included
in the GEMÜ 1436 cPos eco operating
instructions.
If you do not have this operating instructions,
please contact GEMÜ.
2
Mechanical mounting
2.1
Mounting to linear actuators
2.1.1
Preparation of the valve actuator
The actuator must be in the zero position
G
(actuator vented).
Should there be an optical position
G
indicator in the actuator (a red spindle), it
must be removed.
1436 cPos eco
2.1.2
Assembling the travel sensor
10
Pretensioned spring!
10
® Damage to the device.
10
Slowly relax spring.
10
10
11
Attention:Damage to the spindle
surface may lead to failure of the
travel sensor!
11
The travel sensor is assembled using a
mounting kit 1436S01Z... (direct mounting)
12
or 4232S01Z... (remote mounting)
12
consisting of a spring, an operating bush
13
and a threaded adapter (if applicable). The
mounting kit depends on the valve type.
Travel sensor
13
14
14
Spindle
15
1. Pull out the spindle of the travel sensor up
15
to the limit stop.
16
17
17
2. Push the spring over the spindle.
3. Fix the spindle at point a
(the spindle must not be damaged
during this process).
4. Screw the operating bush onto the
spindle.
10 / 20
Operating bush
Compression spring
Mounting kit
a
Advertisement
Chapters
Table of Contents
