Table of Contents
Advertisement
Setup
NOTE: See Typical Installation diagram.
1. Perform Setup procedure for feed system compo-
2.
nents. See feed system manual(s).
2. Place an in-line air pressure regulator, air-water
separator/filter, and shut-off/bleed valve between
the air supply and the control solenoids.
Typical Installation
Material Tank (optional)
Pump
F
. 5
IG
3A0874D
3. Connect each 1/4 in. outside diameter supplied air
line to the corresponding control solenoid. See
Component Identification starting on page 7.
4. Connect chemical lines from feed system to meter-
ing valve material inlets. See Component Identifi-
cation starting on page 7.
Air Supply
Fluid Shut-Off Valve
User Supplied
Air Shut-off and Bleed Valve
Air-Water Separator/Filter
Air Pressure Regulator
Control Solenoids
Metering Valve
Setup
11
Advertisement
Table of Contents
