JUKI HZL-X Series Service Manual page 10

9) Front panel
@2
Notch
C
B
Z
10) Rear panel
○ Remove setscrews @2 and @3 from the front panel.
○ Put a thin screwdriver in the notch in the rising section under the arm and pry
off the front panel and hook A of the rear panel.
○ Opening the right side of the front panel in the direction of the arrow, tap Z
section with your hand to remove hook B located at the bed surface.
○ Lastly, remove hook C located at the lower side of the machine jaw.
○ Remove connectors for SUMI-card, start switch, LED lamp and microcomputer
panel I/F cable from the microcomputer PCB when necessary.
@3
Open
A
○ Remove setscrews @4 , @5 and @6 from the rear panel.
Remove the rear panel with the presser foot lifting lever raised.
@4
Microcomputer PCB
@6
– 8 –
@5