JUKI HZL-X Series Service Manual page 41

No. Item name
18 WIND PWR UP LIMIT
19 Reserved
20 MODEL SELECT
21 0MM SETTING
22 6MM SETTING
23 Reserved
The bobbin winder is provided with the function that winds thread with in-
creased power. This function is used when winding thick thread or an increase
in torque is required. The threshold value for the increase in power is set using
this item of the service mode.
The adjustable range of the threshold value is [20 to 60].
(Default is 40. Adjustment is made in increments of 1.)
Setting is disabled.
Set the "0 (zero) mm position" of the auto-lifter.
When selecting the function number, lift the presser foot with the auto-lifter to
the height that is slightly above 0 mm in advance.
The value displayed on the left represents the current set value. The value
displayed on the right represents the current height of presser foot.
Change the height of presser foot with the "stitch length adjusting" dial or but-
ton and confirm the new set value with "OK" button.
(Default is 200.)
Set the "6 mm position" of the auto-lifter.
When selecting the function number, lift the presser foot with the auto-lifter to
the height that is slightly above 6 mm in advance.
The value displayed on the left represents the current set value. The value
displayed on the right represents the current height of presser foot.
Change the height of presser foot with the "stitch length adjusting" dial or but-
ton and confirm the new set value with "OK" button.
(Default is 537.)
– 39 –
Description